End of Line Deflagration Flame Arrester for a Low-Level Flow Rate

End of Line Flame Arrester Approved to EN ISO 16852 for Atmospheric Explosion

The end of line deflagration flame arrester installed at the end of vent pipes prevents light-back at deflagration of potentially explosive vapour-air, and or gas-air mixtures from outside (atmospheric conditions) to the protected side (e. g. storage tank).

End of line flame arrester can be used for low flow rates in the favourably 180 ° installation.

Range of products / Data Sheet

End of Line Flame Arrester : Explanation

End of Line Flame Arrester = Flame arrester that is fitted with one pipe connection only.

End of line deflagration flame arrester is fitted at the end of vent line. Even at a small pressure difference between storage tank and atmosphere, gas, steam or aerosol escapes through the vent. If this gas, vapor or aerosol is ignited then flame will propagate through the vent line into storage system.

End of line deflagration flame arresters stops flame propagation at atmospheric explosion before flame enters into the storage tank.

Range of products / Data Sheet

Picture: End of Line Flame Arrester

End of Line Deflagration Flame Arrester:  Atmospheric Explosion

Flame arrester that is fited with one pipe connection only. End of line flame arrester protects e.g. the storage tank against atmospheric explosion.

End of Line Flame Arrester Approved for Endurance Burning and Atmospheric Explosion

Flame Arrester that prevents flame transmission during and after endurance burning. Endurance Burning: Steady burning of a flame stabilized at, or close to, the flame arrester element.

Following options of connection are available.:
Male and Female Thread  

Material:
Stainless Steel, Hastelloy or Carbon Steel 

EXPLO­SIONS
GRUPPE
IIAIIB1IIB2IIB3IIB
DN25
1″
DN32
1 1/4″
DN40
1 1/2″
DN50
2″
DN65
2 1/2″
DN80
3″
DN100
4″
DN125
5″
DN150
6″
Top